SINUMERIK GROOVING CYCLE 93 DATA
SPD- Starting point of groove along X- axis .
SPL- Starting point along Z-axis( longitudinal axis).
WIDG- Grooving width .
DIAG- Groove depth.
STA1- Inclined angle .
ANG1-Right flank angle .
ANG2- Left flank angle .
RCO1- Radius outside at left.
RCO2- Radius outside at right.
RCI1- Radius inside at right .
RCI2- Radius inside at left.
FAL1-Finishing allowance on groove base .
FAL2-Finshing allowance of flank .
IDEP- Infeed depth .
DTB- Bottom dwell time.
VARI- Maching type.
VRT- Skip it always
SINUMERIK GROOVING CYCLE 93 DATA
Reviewed by harshal
on
March 10, 2018
Rating:
Reviewed by harshal
on
March 10, 2018
Rating:
